Here is the ShtokCustomWorx NPXL V2 LED Strip PCB Holder. This is the hilt side and for 1" emitters. It is also designed for the short pins option only.

Machined from black ABS. It is not compatible with any third party PCB.

This holder is MagConnect compatible. Magnets are sold separately .

Please note, the magnets are a snug interference fit. They will still need be glued in so the force of the magnets do not pull them out when near each other. We recommend a low viscosity CA glue for this.

Be careful when doing this; the magnets are fragile. Also, it is important to note that due to the tolerances, be sure to check the fitting of the holder inside the hilt before the magnets have been put it and after. The addition of the magnets may expand the holder slightly resulting in a tighter fit. If this is the case, we recommend lightly sanding the outside of the magnets using a sanding drum to reduce the outer diameter slightly. This will stop the holder from expanding after installing the magnets.

Note that the PCB is press fit but it can be further secured using a small dab of hot glue or equivalent. It does also have 2 holes on each side of the holder should you wish to tap them and secure the PCB using screws.